Kenmore 758.144108 Operator's Manual page 7

Water Fill (continued)
Check for possible leaks by
performing the following:
1, Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on the valve cap plunger for
about one second to let out a little
water.
3. Release the plunger.
4. Listen for air bubbles. Look for leaks
around the "E-Z-Fill Side-Cap" and
valve plunger.
5. If you hear air bubbles or see leaks,
retighten the "E-Z-FilI Side-Cap" and
repeat Steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the the
humidifier base to the ring of the grille.
The "E-Z-Fill Side-Cap" must be facing
outward. When positioned properly, the
plunger wiII open and water wilI ftow into
the base. The base will hold the entire
contents of the water bottle. Allow up to
one minute for the water to flow into the
base. Once the bottle is empty, remove it
and refill it as mentioned earlier. Return it
to the right side of the grille. The
humidifier is now filled to capacity.
The water bottle may be filled at anytime
as necessary during operation. To benefit
from Iess frequent filling, let the humidifier
exhaust both the water from the bottle
and base before filling.
The unit is now ready for operation.
Operating Humidifier Controls
The operating controls of your Kenmore
Quiet Comfort whole house humidifier are
located towards the front of the
humidifier.
Familiarize yourself with the controls.
Reference the diagram of the control
area for the correct nomenclature used in
this manual.
To Operate the Controls
Power Light:
When the unit is plugged in and turned
on, the red power light will come on. It
will stay on until the unit is turned off ( | )
or unplugged.
Humidity ControB: @
Adjust the amount of humidity depending
on your needs. The humidifier will turn on
the off as required to maintain leve! of
humidity selected. A medium setting (half
way between the controls rotation) is
recommended, but there are times when
low or high amount of humidity may be
preferred. For constant operation of
humidifier, rotate the control alI the way
clockwise allows for the maximum
amount of humidity to be evaporated into
the air continuously.
tMPOF{TANT: Water damage may result if
condensation starts to form on windows or
wells. Humidity Control setting should be
lowered until condensation no longer forms. 7
Speed Control: @
This humidifier has a three speed fan
control switch. ( ,, ) - Low, ( : ) - Medium
and ( } ) - High. The maximum humidity
output is obtained with the fan control on
High ( _ ).
The higher the air flow speed, the more
water is evaporated and released into the
air. Low speed (.) is the quietest and is
provided for conditions that may not
require as high an evaporation rate.
Refill Light:
When the unit has a smaII amount of
water Ieft in it, the amber refil! Iight wiII
come on and the unit will automatically
shut off.
Off
Power Position
Humidity Speed
ControJ Control
RefHmLight