Check Tire Pressures; Check Condition Of Belts; Lubricate Grease Fittings - Exmark Turf Tracer S-Series Operator's Manual

Maintenance
1. Stop engine and wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Clean area around hydraulic reservoir cap and
remove cap. Oil level should be to the top of the
baffle inside the tank. If not, add oil. Use Exmark
Premium Hydro Oil. Replace hydraulic reservoir
cap and tighten until snug. Do Not overtighten.
Note: The baffle is labeled "HOT" and
"COLD". The oil level varies with the
temperature of the oil. The "HOT" level shows
the level of oil when it is at 225°F (107°C). The
"COLD" level shows the level of the oil when
it is at 75°F (24°C). Fill to the appropriate level
depending upon the temperature of the oil. For
example: If the oil is about 150°F (65°C), fill to
halfway between the "HOT" and "COLD" levels.
If the oil is at room temperature (about 75°F
(24°C)), fill only to the "COLD" level.

Check Tire Pressures

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Check tire pressure in drive tires.
3. Inflate drive tires to 12–16 psi (83–110 kPa).
4. Inflate tires to pressures stated above. Measure
the circumference of each drive tire. Adjust tire
pressures within the above range to try to make
tire circumferences match as closely as possible.
5. Semi-pneumatic caster tires do not need to be
inflated.

Check Condition Of Belts

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Remove the mower deck belt shield to check
mower blade drive belt condition.
3. Look under engine deck to check the pump drive
belt condition.
4. Check all idler arms to be sure they pivot freely.
Disassemble, clean and grease pivot bushings if
necessary.

Lubricate Grease Fittings

Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with NGLI grade #2
multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting Initial
Locations Pumps
36 inch
1. Caster 12
Wheel
Bearings
2. Caster 2
Pivots
3. PTO 1
Engagement
Bellcrank
4. Pump 2
Drive Idler
Pivot
5. Clutch 1
Arm Pivot
6. Pump 2
Control
Bearings
7. Mower 2
Deck Idler
Pivots
Number 4 Idler Pivot (Pump Drive) Located
under engine deck.
Number 5 (Clutch Arm Pivot) Located under
3. Lubricate pivot points with a spray penetrating
lubricant as shown in the Spray Lubricant Chart.
Spray Lubricant Chart
30
Number of Places
48 inch 52 inch
Deck Deck Deck
2 2 2
2 2 2
1 1 1
1 1 1
1 1 1
2 2 2
1 1 1
engine deck.
Service
Interval
Daily
Daily
40 hours
Yearly
40 hours
40 hours
Yearly