Frost Protection Function; Setting The Correct Time; To Program The Timer; Timer Override - DeLonghi DRAGON HM3 Leaflet

pointer
Fig.2
operating time
fig.3
Dragon HM3

Frost protection function

With the thermostat slider in the minimum position and a power
selected, the unit maintains the room at a temperature of about
5˚C, preventing freezing with minimum energy consumption.
Models with 24-hour timer
Using the timer
If you wish to use the timer, position the switch in the middle posi-
tion (Fig. 4).

Setting the correct time

Check the time on your watch. If for example it is 4.00 pm.
(16.00), turn the dial in a clockwise direction until the number 16
is lined up with the triangular pointer (fig.2).
N.B.: Never turn the dial in an anti-clockwise direction!
The timer is in effect an electric clock and works only if the plug is
connected to the power supply. Whenever the plug is disconnect-
ed or there is a power failure, the clock must be re-set.

To program the timer

1) Set the operating times by pushing in with your thumbnail to
the outer rim, the notches on the dial corresponding to the
period required (fig.3) (each notch represents 15 mins.)
2) Make sure that the timer indicates the correct time (see
instructions on setting the correct time).
3) Turn the radiatior on and set it to the heat setting and temperature
level on the thermostat as required.
Once programmed in this way, the appliance will repeat the pre-
established program every day, if the selector is in the

Timer override

If you wish to override the timer settings, push the timer switch to
position 1 (fig.4) manual (timer override).To return to timed oper-
ation push the switch back to the middle position
NOTE: if the timer switch is at the 0 position (fig.4), the heater is
off and will not operate).
0
Heater off
Timer operation
I
Manual (timer override)
3
position.
(fig.4).
fig.4