Electrical Connection; General Instructions; Adjusting The Thermostat - DeLonghi DRAGON HM3 Leaflet

Fig.1
Dragon HM3
Thank you for choosing this De'Longhi radiator. To get the
very best out of your new radiator it is advisable to read
these instructions before using it.This will ensure that you
gain optimum results and use the appliance safely.

General instructions

Take the radiator out of its packing box and remove any poly-
styrene pieces or any other packaging material that might be
lodged inside it.
Make sure that the radiator has not been damaged during transit
and that the mains cable is in working order. Do not operate the
radiator if damaged.
"Easy wheel"system
Turn the radiator upside-down on a rug or a soft surface in order to
prevent damaging the paint finish. Fully unfold the castors by turning
them outwards (Fig. 1).Turn the radiator back to its upright position.

Electrical connection

- Before plugging the radiator into the mains, check that your
supply voltage is the same as that shown on the rating plate of
the radiator.
- If using more than one appliance at a time, it is important to
ensure that the ring main is adequate to cope with the power
requirements.
- It is important to ensure that the socket is adequately earthed.
- This radiator complies with EEC Directive 89/336 relating to
electromagnetic compatibility.
How to use it
Switching on
Plug the radiator in; position the thermostat slider to maximum
and turn the radiator on as follows using the power selector:
• Turn the power selector to position 1 to select minimum out-
put (the light on the left will come on).
• Turn the power selector to position 2 to select medium output
(the light on the right will come on).
• Turn the power selector to position 3 to select maximum out-
put (both lights will come on).

Adjusting the thermostat

Leave the thermostat at its highest setting until the room has
reached the required temperature.Then slowly turn the ther-
mostat slider back until you hear a click.The temperature
selected in this way will then be regulated automatically and
kept constant by the thermostat.
2