Cleaning - Kenmore 790.4507 Series Use And Care Manual

General Cleaning
To Remove and Replace Oven Door
To Remove the Oven Door:
1. Open the door to the fully opened position
2. Pull up the Iock located on both hinge supports and engage it in the hinge levers. You may have to apply a little downward
pressure on the door to pull the locks fully over the hooks.
3. Grab the door bythe sides, pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling
the bottom of the door toward you while rotating the top of the door toward the range to complete@ disengage the hinge
levers.
To Replace the Oven Door:
1. Grab the door bythe sides; place the hinge supports inthe hinge stots. Open the door to the fully opened position.
2. Disengage the lock from the hinge levers on both sides.
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.
3. Close the oven door.
The door is heavy. After removing door, lay it flat on the floor with the inside of the door facing down.
Lock in normal
position
Lock engaged
for door removal
HINGESLOT
Door removed from the range
m
!
Removable External Door Glass Panel
Applicable only to modeis with an external glass panet not hetd with a frame. This design allows you to clean the inside face
of the exterior door panel as well as the hidden face of the door inner glass.
To Remove the External Door Glass Panel:
1. Remove the door as explained above and lay the door flat.
2. Using a screwdriver, remove the 5 screws fastening.
3. Grasp both sides of the giass panel and slowly pull it out of the door upper moiding. Laythe giass flat.
To Replace the External Door Glass Panel:
1. Grasp the sides of the glass panel and carefully insert the glass into the door top moulding.
2. Replace the 5 locking screws.
3. Replace the door onto the range.
Handle the glass panet with care. When dropped on a corner, the glass panet may shatter. This can cause
several personal injury.
25