Garmin GNC 300 Pilot's Manual page 89

Selecting and Loading an Approach
When an arrival airport is selected with the direct-to key (or created and activated
in a route to the arrival airport), the approaches for your arrival airport become avail-
able through the approach select page, which can be viewed by pressing R and
rotating the outer knob. Remember that an airport must be the last waypoint in a
route to select an approach.
To select an approach:
1. Select the destination airport using the
create and activate a route to the destination airport (see Section 5).
R O
2. Press and rotate
K O
3. Rotate (or with the cursor active) to display the desired approach procedure.
C
4. Press twice (if necessary) and rotate
E
5. Press to select the approach.
If an approach procedure has more than one Initial Approach Fix (IAF), you'll
need to select the desired IAF identifier for your approach.
To select an IAF:
O
1. Rotate until the desired IAF flashes.
E
2. Press .
Once the IAF is selected, the approach waypoints will be inserted into Route 0,
replacing the destination airport, and the active route page will be displayed. To
review the active route, rotate the K knob. The scrolling arrow prompt will indicate
which direction to scroll to view additional waypoints, while the 'if', 'ff' and 'mp' des-
ignators will indicate the IAF, FAF and MAP respectively.
D
key, or
to display the approach select page.
O
until the desired approach flashes.
APPROACH NAVI-
APPROACH NAV
GATION
Selecting & Loading
Approaches
Missed Approach
Select the approach.
Select the Initial Approach Fix.
Once the approach is loaded, the active route page
will appear.
SECTION
6
79