To pause the dryer at any time
Open the door or press STOP/CANCEL
To restart the dryer
Close the door and press START.
NOTE: Drying will continue from where the cycle was interrupted
if you close the door and press START within 5 minutes. If the
cycle is interrupted for more than 5 minutes, the dryer will shut
off. You will need to select new cycle settings before restarting
Properly loading your dryer can lower your utility bill and prolong
the life of your garments.
Load the dryer by the amount of space items take up, not by
Do not overload the dryer. This causes uneven drying and
Heavy Work Clothes
10 bath towels
10 hand towels
3 sheets (1 king, 2 twin)
Select the correct cycle and temperature
for your load.
The display shows the estimated cycle time when your dryer is
sensing the dryness level of your load. If a cycle is
using Timed Dry, the display shows the exact number of minutes
remaining in the cycle.
Cool Down tumbles the load without heat during the last few
minutes of all cycles. Cool Down makes the loads easier to
handle. The length of the Cool Down depends on the load size
and dryness level.
Follow care label directions when they are available.
If you use fabric softener sheets, use only ones labeled as
dryer safe. Follow package instructions.
Remove the load from the dryer as soon as tumbling stops to
reduce wrinkling. This is especially important for permanent
press, knits, and synthetic fabrics.
Dry most loads using the preset cycle settings.
Use this chart as a guide to dry various loads. Drying
temperature and Auto Dry Level (Normal Dry) are preset when
you choose an Auto Dry cycle. You can select a different
dryness level, depending
on your load (see "Modifiers").
For a Timed cycle, drying temperature is preset, but the time
can be adjusted.
PRESET CYCLE SETTINGS
(Auto Dry Level)
* Estimated pre-set time
** Actual time