To Remove Belt - Kenmore 116.21312 Owner's Manual

Always follow all safety precautions when
cleaning and servicing the POWER-MATE
TM
wARNING ..........................
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting,
HALF LIGHT POWER-MATE
TM
1, Remove light
cover by lifting at
arrow as shown.
2. Push in and turn
bulb counterclock-
wise to remove.
3. Replace the
bulb. Bulb must not
be higher than 15
Watt& Close light
cover until it snaps
in place
NOTE: See PARTS AND FEATURES for
Bulb #_
1
FULL LIGHT POWER-MATE
TM
2. Push in and turn
bulb counterclock-
wise to remove,
3. Replace the
bulbo Bulb must not
be higher than 15
Watts. Close light
cover until it snaps
in place
1, Remove light
cover by pressing
in and lifting both
sides as shown
Push In
And Turn
NOTE: See PARTS AND FEATURES for
Bulb #,
Disconnect cleaner from electrical outlet,
Check and remove hair, string and lint build*
up frequently in the POWER-MATE
TM
brush
and brush support areas,, If build-up
becomes excessive, disconnect POWER-
MATE
TM
from wand and follow the steps
below, Instructions can also be found under
the light cover
TO REMOVE
BELT:
I. Remove light cover
and light bulb as
shown under LIGHT
BULB CHANGING
2, Unscrew the
POWER-MATE
TM
cover screws,
15