Kpw937C4> Air Direction Adjustment Grille - Daikin FTXN09KEVJU Operation Manual

Optional Accessories
13.7 <KPW937C4> Air Direction Adjustment Grille
Component parts
Air direction
Name 1
adjustment grille
Shape
Qty.
Selection of installation site
Use the air direction adjustment grille for installation at a location that fits the following conditions.
1.When installing the outdoor unit near the neighbouring house.
2.When changing the airflow direction to prevent exhaust blowing directly onto passersby or garden plants.
Cautions for usage
Be sure to perform the following as installation precautions to ensure correct and safe use of the air direction
adjustment grille.
1.Be sure to stop the operation before installation.
2.Avoid short-circuits during installation.
3.When using the unit in areas with snow, install the grille to create a left-right or downward airflow.
Do not install the grille to create an upward airflow to prevent snow accumulating in the air outlet of the outdoor unit as this may
damage the unit.
4.Be careful of foreign substances such as dead leaves, which may accumulate on the air outlet after installing the grille to create
an upward airflow.
5.Do not use screws other than those provided. Tighten the screws securely without any looseness.
Installation of air direction adjustment grille
Pitch of the installation screws for the air directrion adjustment grille ( ) is 17-1/8" (434mm)
Installation can be performed in 4 diections:top, bottom, left and right.
Temporarily secure the air direction adjustment grille ( ) using 4 screws ( ), check the installation angle, and then tighten
the screws.
<Round outlet grille>
1.Install the air direction adjustment grille ( ) on the
front panel using 4 screws ( ).
The prepared holes on the front panel are a concave
shape and not through-holes. Create a through-hole
by tightening the screw ( ) in the prepared hole.
Do not use a borer for the prepared holes to avoid
damaging the parts inside. (4 positions)
2.Seals ( ) and spacers ( ) are not necessary.
4
Cross section of
prepared hole
2
1
174
Be sure to check that the following parts are included before installation.
M4 x 30 Screw
2
1 pc . 4 pcs.
1
2
2
5
Installation
3 4
manual
One sheet (this sheet)
1
1 2
<Square outlet grille whose
thickness is 5/8" (15mm) or less>
1.Install the air direction adjustment grille ( ) on the
front panel using 4 screws ( ). The prepared holes
of the front panel are located between the lattice of
the outlet grille and approx. 10mm inside from the
outlet grille surface. (4 positions) Do not use an
electric screwdriver if the front panel is made of resin.
2.Seals ( ) and spacers ( ) are not necessary.
4
2
1
EDUS041111_a
Seal 5 Spacer
1 pc . 4 pcs.
in vertical and horizontal directions.
1
2
5
Example of
prepared hole
Room Air Conditioners K-Series