Preparation before Operation
2
Position
–
correctly!
3
1
Set.
Pull.
Remote controller
holder
ATTENTION
About batteries
•
When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
•
When the system is not used for a long time, take the batteries out.
•
The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance
occurs within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).
•
The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
•
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as inverter-type lamps) is in the room. Consult the
shop if that is the case.
•
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
8
To set the batteries
1.
+
and
Slide the front cover to take it off.
2.
Set 2 dry batteries AAA.LR03 (alkaline).
3.
Set the front cover as before.
To fi x the remote controller holder on the wall
1.
Choose a place from where the signals reach
the unit.
2.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3.
Place the remote controller in the remote
controller holder.
Turn the breaker ON
•
Turning ON the breaker closes the fl ap. (This is a normal procedure.)