Moving And Storing The Unit - Olivetti d-Copia 200D Operation Manual

MOVING AND STORING THE UNIT

Moving instructions
When moving the unit, follow the procedure below.
When moving this unit, be sure to remove the toner/developper cartridge
in advance.
1
Turn the power switch off and remove the power cord from the
outlet.
2
Open the side cover and front cover, in that order. Remove the
toner/developper cartridge and close the front cover and side
cover, in that order.
To open and close the side cover and front cover, and to remove the toner/
developper cartridge, see "TONER/DEVELOPER CARTRIDGE
REPLACEMENT" (p.57).
3
Raise the handle of the paper tray and pull the paper tray out
until it stops.
4
Push the center of the pressure plate down until it locks in
place and lock the plate using the pressure plate lock which
has been stored in the front of the paper tray.
5
Push the paper tray back into the unit.
6
Lock the scan head locking switch (p.9).
When shipping the unit, the scan head locking switch must be locked to
prevent shipping damage.
7
Close the multi-bypass tray and the paper output tray
extension, and attach the packing materials and tape which
were removed during installation of the unit. See "PREPARING
THE UNIT FOR INSTALLATION" (p.8).
8
Pack the unit into the carton. See "CHECKING PACKED
COMPONENTS AND ACCESSORIES" (p.8).
Proper storage
Store the supplies in a location that is:
• clean and dry,
• at a stable temperature,
• not exposed to direct sunlight
Store paper in the wrapper and lying flat.
• Paper stored out of the wrapper or in packages standing on end may curl or get
damp, resulting in paper misfeeds.
9
73