Important Safety Information - Hatco STM-4G Series Installation & Operating Manual

Table of Contents

Advertisement

IMPORTANT! Read the following important safety information to avoid personal injury
or death, and to avoid damage to the equipment or property.
WARNINGS
To prevent electrical shock or injury, turn the
power switch OFF, disconnect the unit from
the power source and allow to cool before
performing any maintenance.
For safe and proper operation plug unit into
a properly grounded electrical outlet of the
correct voltage, size and plug configuration.
If the plug and receptacle do not match,
contact a qualified electrician to determine
the proper voltage and size. Install the proper
electrical outlet if needed.
This appliance is not jet-proof construction.
To assure safe and proper operation do not
use jet-clean-spray to clean this appliance.
The appliance is not waterproof. To avoid
electrical shock or personal injury, DO NOT
submerge in water. Do not operate if it has
been submerged in water.
To avoid electrical shock or personal injury,
DO NOT insert into the unit a water tank that
is wet on the outside.
To prevent any injury, discontinue use if
power cord is frayed or worn.
To prevent any injury or damage to the unit
do not pull unit by power cord.
If the power supply cord is damaged, it must
be replaced by Hatco, an Authorized Service
Agent, or a person with similar qualifications
to avoid a hazard.
This appliance is not suitable or designed for
operation on ships, airplanes, tourism cars,
or similar locations. A qualified electrician
must evaluate the risk of operation to avoid
personal injury or damage to the appliance.
Hot steam will escape from cabinet when
door is opened and injury may occur if user
comes in contact with steam or inside of
steam oven cabinet wall.

IMPORTANT SAFETY INFORMATION

To assure safe and proper operation
additional
depending upon products being thawed and
local codes applying to sink thawing
techniques.
To avoid the risk of injury, scalding or
damage to the appliance DO NOT heat food
in sealed jars or tins. Pressure will build up
inside them and explode.
The unit must be transported in an upright
position. The water must be drained from the
unit. Failure to do so may result in damage to
the unit or personal injury.
To avoid any injury or damage, the steamer
must
only
personnel.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at 414-
671-6350 or International fax 414-671-3976.
This product has no "user" serviceable
parts. To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are
specified
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.
1
cleaning
may
be
be
serviced
by
Agents
and
Genuine
to
operate
safely
Form No. STMSM-1007
required
qualified
Hatco
in
the

Advertisement

Table of Contents
loading

Table of Contents