Solving Setup Problems; Noise After Ink Installation; Software Installation Problems - Epson WorkForce Pro WP-4520 User Manual

• Network Setting or Wi-Fi/Network Setting: Resets all network settings.
• All except Network or All except Wi-Fi/Network : Resets all control panel settings, except for
network settings.
• All Settings: Resets all control panel settings.
You see a confirmation screen.
4. Select Yes and press the OK button to reset the selected settings. (Select No and press the OK
button if you want to cancel the operation.)
Parent topic:

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Noise After Ink Installation

Software Installation Problems

Control Panel Setup Problems
Parent topic:
Noise After Ink Installation
If you hear noises from your product after installing ink, try these solutions:
• Make sure you removed the foam and plastic protective materials from inside the product.
• The first time you install ink cartridges, the product must prime its print head. Wait until priming
finishes before you turn off the product, or it may prime improperly and use excess ink the next time
you turn it on. Your product is finished priming the print head when the
• If the product's print head stops moving or making noise, and the charging process has not finished
after 15 minutes, turn off your product. Turn it back on and check to see if charging is still in progress.
If it is still in progress, contact Epson for help.
Parent topic:
Software Installation Problems
If you have problems while installing your product software, try these solutions:
• If you still have problems installing software, disconnect the cable and carefully follow the instructions
on the Start Here sheet. Also make sure your system meets the requirements for your operating
system.
Solving Problems
Solving Problems
Solving Setup Problems
230
power light stops flashing.