Digital Link Connections (Connecting With A Twisted Pair Cable Transmitter) - Panasonic TH-47LFX6 Operating Instructions Manual

Using Network Function

DIGITAL LINK Connections (connecting with a twisted pair cable transmitter)

This device is equipped with functions that allow Ethernet signals from a twisted pair cable transmitter to be received through a
LAN cable along with video/audio signals.
Network connections via twisted
pair cable transmitter
PC
(commercial)
Note:
Con gure the settings in "Network Setup" when using a DIGITAL LINK connection. (see pages 43 to 45)
Precautions for use while connecting with a twisted pair cable transmitter
Installing / Connecting
Ask the dealer or a quali ed technician to carry out the cable wiring work for DIGITAL LINK connections.
Insuf cient wiring work may cause the inability to apply the cable transmission characteristics and cropped
or fuzzy images and sounds.
The transmission distance between the twisted pair cable transmitter and the device is up to 100 meters.
Exceeding this distance can cause cropped images or sounds, as well as LAN communication errors.
Do not use a hub between the twisted pair cable transmitter and the Display.
When connecting to the Display using the twisted pair cable transmitter (receiver) of other maker, do not
use another twisted pair cable transmitter between the twisted pair cable transmitter of other maker and
this device. The images and sounds may be interrupted or become unstable.
If possible, lay the cable so that it is extended and not coiled in order to minimize both external and internal noise.
Lay out cables of the twist pair cable transmitter and this product away from other cables, especially from
the power supply cable.
When laying multiple cables, keep them as close together as possible running parallelly and not bundled.
After laying the cable(s), make sure that the signal quality in "DIGITAL LINK status" is -12 dB or below.
Twisted pair cables
Use a LAN cable between the twisted pair cable transmitter and the device that conforms to the following
conditions.
It meets or exceeds CAT5e standards
It is a shielded cable (with a connector)
When laying the cable(s), use an instrument such as a cable tester or cable analyzer and check whether the cable
characteristics are CAT5e or above. When using a relay connector along the path, also include this in the measurements.
Do not pull cables hard. Also avoid forcefully bending or folding them.
Other
This device is compatible with our Digital Interface Box (ET-YFB100). For the twisted pair cable transmitter
of the other maker, refer to the following URL. (http://panasonic.net/prodisplays/products/47lfx6/index.html)
50
DIGITAL LINK terminal
LAN cable LAN cable
(commercial)
Hub or broadband router
Display (rear surface of the main body)
Remove the terminal cover (see page 9)
Twisted pair cable
transmitter
It is a straight cable
It is a solid cable