Cleaning And Maintenance - Panasonic TH-47LFX6 Operating Instructions Manual

Safety Precautions
CAUTION
When using the LCD Display
Be sure to disconnect all cables before moving the Display.
• If the Display is moved while some of the cables are still connected, the cables may become damaged, and re or
electric shock could result.
Disconnect the power supply plug from the wall socket as a safety precaution before carrying out any
cleaning.
• Electric shocks can result if this is not done.
Clean the power cable regularly to prevent it becoming dusty.
• If dust built up on the power cord plug, the resultant humidity can damage the insulation, which could result in re.
Pull the power cord plug out from the wall outlet and wipe the mains lead with a dry cloth.
Do not burn or breakup batteries.
• Batteries must not be exposed to excessive heat such as sunshine, re or the like.
Power supply
• Install the product near an electrical outlet so that the plug can be unplugged immediately when an abnormality
occurs.
• For a wall installation, used a power outlet which can be unplugged immediately when an abnormality occurs.
• This product is energized when the power plug is inserted to a socket. To cut off the power completely, the power
plug must be unplugged from the socket.
Cabinet
• Corner part of the metal cabinet is a potential injury hazard.
• To lift the product, hold the handles for the precaution of fall. Injury or damage may be caused.

Cleaning and maintenance

About the glass surface
• If ngerprints or dirt are on the glass surface, clear image cannot be obtained. Please be careful not to scratch or
make it dirty.
Dirt on the glass can be cleaned with a sponge, cloth or squeegee. Do not use strong acidic or alkaline
solution, especially detergent contains uoride, otherwise the antire ection material on the glass surface will
be affected to have irreparable damage.
The glass has been specially treated. Wipe the glass gently using only a cleaning cloth or a soft, lint-free
cloth.
• If the glass is particularly dirty, wipe with a soft, lint-free cloth which has been soaked in pure water or water in
which neutral detergent has been diluted 100 times, and then wipe it evenly with a dry cloth of the same type until
the surface is dry.
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
• If the cabinet is particularly dirty, soak the cloth in water to which a small amount of neutral detergent has been
added and then wring the cloth dry. Use this cloth to wipe the cabinet, and then wipe it dry with a dry cloth.
• Do not allow any detergent to come into direct contact with the surface of the Display. If water droplets get inside
the unit, operating problems may result.
• Avoid contact with volatile substances such as insect sprays, solvents and thinner, otherwise the quality of the
cabinet surface may be adversely affected or the coating may peel off. Furthermore, do not leave it for long periods
in contact with articles made from rubber or PVC.
4