Panasonic TH-47LFX6 Operating Instructions Manual page 13

Maintaining air lters
The cooling structure of the Display is designed to circulate air taken in from outside inside the Display using fans. Air
lters are built into the inlet and outlet.
When "Filter" is displayed on the screen as you turn on the power, or when the
power indicator is blinking green and orange alternately, there is accumulated
dust on the air lters. Check the condition of the air lter and fan in "Maintenance
Information" in the Setup menu, and clean or replace the air lter and inspect the
fan as necessary. (see page 42)
How to remove air lters
Always unplug the power plug before removing air lters.
1
Loosen the decorative screws on
the exhaust vent sections until
they turn freely.
2
Remove the lter cover, and pull
out the air lter.
Cleaning air lters
To clean the air lter, soak in a neutral detergent diluted 200 times with water, rinse well in water, and leave to
dry in the shade.
Notes:
• Air lters must be installed before using the Display. The absence of an air lter may cause failure in the
Display due to the intake of foreign matter or dust.
• When an air lter is damaged or is unobtrusively soiled even after cleaning, replace the air lter with a new
one. Contact your sales agent for replacement.
• The amount of foreign matter or dust adhering to air lters varies depending on the installation location and the
used hours. Increase the frequency of cleaning in locations where dust can easily accumulate.
• Do not remove the wire mesh below the air lter.
• Do not touch the fans or wiring inside the Display.
• When removing air lters from or installing into the Display set on a high place, take care of your own safety,
and avoid the concerned parts falling.
• Clean the air lters approximately once every 3 months and replace them approximately once a year.
Decorative screw
Wire mesh
Fan
• There is no fan in the inlet.
Safety Precautions
Outlet
Inlet
Air lter
Filter Cover
5