Overview; Egs5110P - EnGenius EGS5110P User Manual

G S
ETTING TARTED

1.1 Overview

The EGS Smart Switch Series are smart switch devices specially tailored for access
points and IP surveillance applications. The Smart Switch Series provide simple, yet,
powerful PoE manageability with features such as: Full IEEE802.3AT/AF ports, inter-
nal power supply, PoE port management, loopback detection, and IGMP snooping.
The following section provides an overview of the external device views. It also pro-
vides a brief description of the ports and LEDs.

1.1.1 EGS5110P

A B C
F P
RONT ANEL
A Power LED
B PoE Maximum LED
C System Fault LED
D Factory Reset
E LED Mode Selector
F PoE Mode LED
G LAN Mode LED
H RJ-45 LAN Ports
I SFP Ports
D E F G
Figure 1-1 Front Panel
OFF = The device is not powered on.
ON = The device is receiving power.
OFF = The maximum power draw by other devices has not been
reached.
ON = The maximum power draw by connected devices has been
reached.
OFF = The device is operating.
ON = A system fault is detected.
Press this to reset the device to factory default settings
Press this to change between LAN and PoE mode.
OFF = The device is not in PoE mode.
ON = The device is in PoE mode.
OFF = The device is not in LAN mode.
ON = The device is in LAN mode.
10/100/1000Mbps RJ-45 LAN ports.
Small form factor pluggable ports.
1-1
H
D
ESCRIPTION
O
VERVIEW
I