Operation
STD.2 Notes
Master Dimmer
Warm White & Cool
White Selection
White Macros
Strobe
ID Address
Selection
-12-
These notes intent to clarify the way the STD.2 DMX personality works.
• Channel 1 controls the intensity of the currently projected color.
• When the slider is at the highest position (255) the intensity of the output is at its
maximum.
• Channels 2 and 3 control the intensity ratio of the Warm White and Cool White LEDs
respectively.
• When each of these sliders is at the highest position (255), the intensity of the
corresponding color is at its maximum.
• You can combine channels 2 and 3 to create over 60,000 shades of white.
• Channel 4 selects the required White Macro.
• Channel 4 has priority over channels 2 and 3.
• Channel 1 controls the intensity of the Color Macro.
•
Channel 5 controls the strobe frequency (not the intensity) of channels 2~4.
•
Channel 5 strobes channels 2 and 3 when not running macros, allowing the
individual faders (Warm White and Cool White) as well as channel 1 (Dimmer) to
control the output intensity.
•
Channel 5 strobes channel 4 when running macros, allowing channel 4 to select the
white macro and channel 1 to control the output intensity
• Channel 6 selects the target ID address.
• Each independent DMX address may have up to 66 independent ID addresses.
• An ID address of 0 will activate all ID address locations.
COLORado™ 1 VW Tour User Manual Rev. 01d