Using Bluechart G2 Vision; Navigating With A Garmin Autopilot - Garmin 400/500 Owner's Manual

Using BlueChart g2 Vision

Optional BlueChart g2 Vision preprogrammed SD cards allow
you to get the most out of your unit. In addition to detailed marine
charting, BlueChart g2 Vision has the following features:
• Mariner's Eye 3d—provides a view from above and behind
the boat for a three-dimensional navigation aid
BlueChart g2 Vision Mariner's Eye 3D is more detailed than the
preloaded data.
• fish Eye 3d—provides an underwater 3D view that visually
represents the sea floor according to the information on the chart.
• fishing Charts—provides a view of the chart with enhanced
bottom contours and without navigational data. This chart works
well for offshore deep-sea fishing.
• High Resolution Satellite imagery—provides high-resolution
satellite images for a realistic view of the land and water on the
Navigation chart.
• aerial Photos—provides a view of marinas and other
navigationally significant aerial photos to help you visualize your
surroundings.
• detailed Roads and POi data—provides a view of roads,
restaurants, and other points of interest (POIs) along the shore.
GPSMAP 400/500 Series Owner's Manual
• Current data—provides a view of current-station information
(page
• auto guidance—uses the chart data and specified boat safe
depth to determine the best course to your destination
NOTE: You cannot transfer BlueChart g2 Vision data from the SD
card to your computer for backup or viewing purposes. You can only
(page 16). The
use the SD card on BlueChart g2 Vision-compatible Garmin GPS
units.

Navigating with a Garmin Autopilot

When you start any type of navigation (go To, Route To, guide
To, or follow Track), if you are connected to a compatible Garmin
autopilot, you are prompted to engage the autopilot.
36).
Where To?
(page 43).
33