Using Simulator Mode; Viewing System Information; Restoring The Original Factory Settings; Inserting And Removing Sd Cards - Garmin 400/500 Owner's Manual

Gpsmap 400/500 series
Table of Contents

Advertisement

Getting Started
For more information about GPS, visit the Garmin Web site at
www.garmin.com/aboutGPS.

Using Simulator Mode

Simulator mode turns the GPS receiver off for use indoors or for
practice. The unit does not track satellites in simulator mode.
CaUTiON: Do not try to navigate using simulator mode because the
GPS receiver is turned off. Any satellite signal-strength bars shown
are only simulations and do not represent the strength of actual
satellite signals.
To turn on Simulator mode:
1. From the Home screen select
2. Select
Setup
to set speed, track control, and position.

Viewing System Information

You can view the software version, the basemap version,
supplemental map information (if applicable), the unit ID number,
and your XM
WX Satellite Weather
®
You may need this information to update the system software or to
purchase additional map data information.
From the home screen, select
information.
6
Configure
>
System
> Simulator.
Radio ID (if available).
®
Configure
>
System
>
System

Restoring the Original Factory Settings

NOTiCE: This procedure deletes any information you have entered.
1. From the Home screen, select
Information
>
Factory
Settings.
Yes
2. Select
to restore all factory settings, or select
The unit reboots and prompts you to adjust unit settings

Inserting and Removing SD Cards

Your unit supports Secure Digital (SD) cards. Insert optional
BlueChart
g2 Vision
SD cards to view high-resolution satellite
®
®
imagery and aerial reference photos of ports, harbors, marinas and
other points of interest. Insert blank SD cards to transfer data such as
waypoints, routes, and tracks to another compatible Garmin unit or
a computer
(page
38). The SD card slot is located on the lower-right
corner of the unit.
To insert the SD card, open the access door and press the SD card in
until it clicks. Press the card in again and release it to eject it from
the chartplotter.
Configure
>
System
>
System
No
to cancel.
GPSMAP 400/500 Series Owner's Manual
(page
3).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents