Level Washer - Kenmore Galaxy One-speed automatic washer Owner's Manual And Installation Instructions

G. LEVEL WASHER
Leveling your washer properly pre-
vents excessive noise and vibration.
To install front legs: STEP 5. Move washer to its final
STEP 1. Prop front of washer up (about location.
4 in [10.2 cm]). Use a wood block or STEP 6. Tilt washer forward until rear
another object that will support the weight of washer is at least 3 in (7,6 cm) off
of the washer. If washer was placed floor. You may hear the self-adjusting
against a wall, move the washer out
slightly before tipping it up.
STEP 2, With one of the legs in hand,
screw lock nut onto leg d in (9.5 mm)
from top of leg base. This is the
recommended initial setting.
rear legs click into place, Lower washer
to floor. Check levelness of the washer
by placing a level on top of the washer,
first side-to-side; then front4o-back.
3/8 in
(9.5 ram)
STEP 3. Screw leg into washer base
by hand until nut reaches washer base.
Repeat for other leg.
STEP 7. If washer is not level, prop
up the front of the washer and adjust
the legs up or down as necessary, Lower
washer and reset self-adjusting rear legs
(as in Step 6). Repeat Step 7 until the
washer is level.
STEP 8. When washer is in its final
location and level, use a _ in (1.43 cm)
open-end wrench to turn nuts on front
legs tightly against washer cabinet, If nuts
are not tight against washer cabinet, the
washer may vibrate.
STEP 4. Tilt washer backward until
front of washer is off the wood block.
Remove wood block. Gently lower
washer to floor.
19