Maytag W10550279A Use & Care Manual page 15

TROUBLESHOOTING
f First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.
In U.S.A. www.maytag.com/product_help - In Canada www.maytag.ca.
if you experience Possible Causes Solution
Not enough water
in washer
Washer won't run or fill,
washer stops working
Load not completely covered
in water.
Check for proper water supply.
This is normal operation for an HE low-water washer. The load will
not be completely under water. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
iMPORTANT: Do not add more water to washer. The added water
lifts the load off the washplate, resulting in less cleaning.
Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Washer won't run
or fill, washer stops
working (cont.)
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Solution
Plug power cord into a grounded 3-prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
Washer may be stopped to reduce suds.
Remove several items, rearrange load evenly around the
washplate. Do not load garments directly over the center
of the wash plate. Close lid and press START/PAUSE.
Add only 1 or 2 additional garments after washer has started.
Do not add more water to the washer.
15