Registering Bluetooth Device (Pairing) - Kenwood KDC-U4549SD Instruction Manual

Registering Bluetooth Device
(Pairing)
Registering from Bluetooth devices
Press SRC to turn on the power.
1
Start registering this unit by operating
2
the Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit (pairing). Select
"KENWOOD BT CD/R-3P1", "KCA-BT300" or
"KCA-BT200" from the list of connected
units.
Input the PIN code ("0000") in the
3
Bluetooth device.
Check that registration is complete on
the Bluetooth device. PIN code is set to
"0000" as the default. You can change this
code. Refer to [PIN CODE EDIT] under
<Bluetooth Setup> (page 25).
By operating the Bluetooth device, start
4
hands-free connection.
Registering from this unit
1
KDC-U549BT
Press to enter Bluetooth mode.
/
KDC-U4549SD
Press and hold the volume knob to enter
Bluetooth mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
Turn the volume knob to select [DEVICE
4
SEARCH], then press to enter.
Press the volume knob to search for the
5
Bluetooth device.
When search is completed, "FINISHED" is
displayed.
Turn the volume knob to select a
6
Bluetooth device name, press to confirm.
"PAIRING" is displayed (KDC-U4549SD/
7
KDC-U4549 with KCA-BT300 only)
If "PAIRING OK" is displayed, proceed to
step 10.
If "PIN CODE NG" is displayed, proceed to
steps 8.
Input the PIN code
8
KDC-U4549
■
Turn the volume knob to select the
number.
To move to the next digit, press ¢.
■
To delete the last digit, press 4.
■
Press the volume knob to transmit the
9
PIN code.
If "PAIRING OK" is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
Registering Special Bluetooth device.
Hold to finish the procedure.
10
■
To exit Bluetooth mode, press
■
If there are 5 or more Bluetooth devices
registered, you cannot register a new
Bluetooth device.
Registering Special Bluetooth device
1
KDC-U549BT
Press to enter Bluetooth mode.
/
KDC-U4549SD
Press and hold the volume knob to enter
Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [S-DVC
4
SELECT], then press to enter.
Turn the volume knob to select a device
5
name, press to confirm.
Go through the procedure step 4
6
of <Registering from this unit> and
complete the registration (pairing).
■
If the device name is not in the list, select
"OTHER PHONE".
SRC.
KDC-U4549
English
23