Listening To The Radio; Changing The Frequency Steps; Adjust [Settings] Mode Settings - Kenwood KDC-U4549SD Instruction Manual

Listening to the Radio

1 Press SRC to select "TUNER".
Press BAND repeatedly to select a band
2
(FM1/ FM2/ FM3/ AM).
Press 4 / ¢ to search for a station.
3
Using the remote controller (RC-405)
#FM+ / *AM– : Selects band.
4 / +¢
: Selects station.
1 – 6 : Selects preset station.

Changing the frequency steps

You can change the frequency step of FM/
AM:
FM : 50 kHz to 200 kHz
AM : 9 kHz to 10 kHz
Press and hold
1
power.
Item
Selects the tuning mode for 4 / ¢ buttons.
SEEK MODE
AUTO1 *: Automatically search for a station. ; AUTO2: Search in the order of the stations in the preset memory. ;
MANUAL: Manually search for a station.
AUTO MEMORY YES: Automatically starts memorizing 6 stations with good reception. ; NO *: Cancels (automatic memorizing is
not activated). (Selectable only if [NORMAL] is selected for [PRESET TYPE].) (page 9)
MONO SET ON: Improves the FM reception (but the stereo effect may be lost). ; OFF *: Cancels (stereo effect resumes).
10
English
■
Press and hold for about 2 seconds to memorize the current station.
■
Press briefly to recall memorized station.
SRC to turn off the
Selectable setting (Preset: *)
While pressing number buttons 1 and 5,
2
press SRC.
Release your fingers from the buttons after
the display appears.
■
To restore the initial setting, repeat the same
procedure.
■
When the frequency step is changed, the
frequencies in the memory are deleted.

Adjust [SETTINGS] mode settings

While listening to the radio...
Press the volume knob to enter
1
[FUNCTION] mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to make a
3
selection, then press to confirm.
See table below for selection.
4 Hold to finish the procedure.