Programming - Miele KM 6314 Operating And Installation Manual

To select programming mode
To set the programme
To set the status
You can change the default settings of the programme
options (see chart). Several settings can be altered in
succession.
After selecting programming mode, P (Programme) and S
(Status) will appear in the timer display. On hobs with 3
cooking zones, an additional indicator will appear at the rear
left.
The programme is shown in the cooking zone displays at the
front left and rear left. Example:
Programme 03 = front left 0, rear left 3
Programme 14 = front left 1, rear left 4
The status is shown in the front right cooking zone display.
Once you have left the programming mode, the hob will be
reset automatically. This is completed when an indicator
above the s sensor lights up briefly.
Do not switch the hob on again until the reset process is
completed.
^ With the hob switched off, touch the s and $ sensors at
the same time until the safety lock indicator lamp flashes.
^ To set the units position first touch the sensor for selecting
the rear left cooking zone and then touch the relevant
number on the numerical keypad.
^ To set the tens position first touch the sensor for selecting
the front left cooking zone and then touch the relevant
number on the numerical keypad.
^ Touch the sensor for selecting the front right cooking zone
and then touch the relevant number on the numerical
keypad.

Programming

45