Advertisement
Installing Cooking Components
Important:
Before cooking on your grill the first
time, wash the cooking grids and warming rack with
warm, soapy water. Rinse and dry thoroughly.
Season with cooking oil regularly. After cooking is
completed, turn grill to HIGH setting for about five
minutes to burn off excess grease or food residue.
1. Place the 2 Flame Tamers on the lower ledge
above burners. See Fig. 8.
2. Evenly space the Cooking Grids (cross braces
are bottom side) on the ledge above the
Flame Tamers.
3. Place the Secondary
Cooking
Rack into the
slots on the upper left and upper right of Grill
Head. See Fig. 8.
Connecting
A Liquid Propane
Gas (LPgas)
Tank To Your
Grill
Hang your filled gas tank on the top Tank
Hook. The ring foot of the gas tank will rest
on the Tank Holder. See Fig. 9. Make sure
the LP gas tank valve is in the full OFF
position.
(Turn clockwise
to close.)
2. Check the tank valve to ensure it has proper
external
mating threads to fit the hose &
regulator assembly provided. (Type 1 connec-
tion per ANSI Z21.58a-1998)
3. Make sure all burner valves are in the OFF
position.
4. Inspect the valve connection
port and regulator
assembly.
Look for damage or debris. Remove
any debris. Inspect hose for damage. Never
use damaged or plugged equipment.
5. When connecting
the hose and regulator
assembly
to the tank valve, hand tighten nut
clockwise
to a full stop.
Do Not use a
wrench to tighten because it could damage
the Quick Coupling
Nut and result in a
hazardous condition.
6. Open the tank valve fully (counterclockwise).
Use a soapy water solution to check all
connections
for leaks before attempting
to light
your grill. See "Checking
for LP Gas Leaks"
on page 12. If a leak is found, turn the tank
valve off and do not use your grill until the
leak is repaired.
Disconnecting
A Liquid Propane
Gas (LP gas)
Tank From Your Grill
.
Turn the burner valves and LP gas tank valve
to the full OFF position.
(Turn clockwise
to
close.)
Detach the hose and regulator assembly from
the LP gas tank valve by turning
the Quick
Coupling Nut counterclockwise.
Figure
8
SECONDARY
COOKING
RACK
COOKING
GRID
FLAME
TAMER
SLOTS FOR
RACK
BACK
BURNER
Figure
9
ALREADY
CONNECTED
TOADAPTOR
J
J
..... QUICK
COUPLING
NUT
CAUTION: When the appliance
is not in use, the
gas must be turned off at the supply tank.
Congratulations
Your Kenmore
LP gas grill is now ready for
use. Before the first use and at the beginning
of each season (and whenever
the LP gas
tank has been changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according
to
instructions
found on page 12 of this
manual.
11
Advertisement
