Kenmore 116.32189 Owner's Manual page 18

BELT ROUTING
Correct Routing of Belt
(Selector in Carpet Position)
Assembly
Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Belt on Selector Shaft)
Assembly CarpeYBare FIoor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector in Bare Floor Position)
Brush Carpet/Bare Floor
Assembly Belt Selector Shaft
Press firmly, checking to see that each
end is completely inserted.
Belt
\
Agitator_
Assembly
Check to see that the belt is centered in
the belt groove. Turn the brush assembly
with your fingers to see that it turns freely°
To re-attach the base plate, insert the
tabs into the slots along the front edge of
the base, Place the vacuum in full upright
position, Lower the base plate to its origi-
nal position,
Full Upright Position
Tab Locations
As the base is lowered the inner areas
will brush against the dust compartment
wheels. A gentle pull outward may assist
in reassembty.
Two Locking Tabs Press
the
base plate
clown until
the two
locking tabs
snap into
place.
Re-install the
two screws
that secure
the base
plate.
Screws
Return the cleaner to the upright position
before plugging into the electrical outlet,
18