Carpet/Bare Floor Selector - Kenmore 116.32189 Owner's Manual

Turn off cleaner. Select a pile height set-
ting by tilting the cleaner back until front
wheels are lifted slightly off the floor as
illustrated.
Slide the adjustment lever to the correct
setting
SUGGESTED PILE HEIGHT SETTINGS
You may need to raise the height to make
some jobs easier, such as scatter rugs
and longer pile carpets° Suggested set-
tings are:
HIGH: shag carpet, long pile, plush, scat-
ter rugs.
rilED: medium to long pileo
LOW: short to medium pile..
EX LOW: very low pile.
I:1
SOME MODELS
Bare floor setting: Rotate the
carpet/bare floor selector all the way back
and down toward the bottom of the nozzle
until it locks into place.
In this position the agitator does not
revolve. This setting should be used for
cleaning hardwood and tile floors and
when any attachments (tools) are
used.
Carpet setting: Slide the selector all the
way forward and up to the carpet
position.
In this position the agitator wilt turn°
When carpets are being cleaned the
selector should be in this position,
NOTE: For longer belt life, turn vacuum
off before moving selector, otherwise
make sure the selector is pushed fully
and quickly as possible to the desired
position. Failure to do so can cause the
belt to rub on the selector shaft and may
result in the belt becoming hot and creat-
ing a burning rubber smell.
Carpet/Bare
Fioor Selector
To Bare Floor \
Position
To Carpet
Position
7