Wpa(2) Authentication - ZyXEL Communications AMG1202-T10A User Manual

8.2.4 WPA(2) Authentication

Use this screen to configure and enable WPA or WPA2 authentication. Click the Wireless LAN link
under Network to display the AP screen. Select WPA, WPA2 or WPAMixed from the Security
Mode list.
Figure 47 Network > Wireless LAN > AP: WPA(2)
The following table describes the wireless LAN security labels in this screen.
Table 30 Network > Wireless LAN > AP: WPA(2)
LABEL
Security Mode
Encryption
WPA Compatible
ReAuthentication
Timer
Idle Timeout
AMG1202-T10A User's Guide
DESCRIPTION
Choose WPA or WPA2 from the drop-down list box.
Select the encryption type (TKIP, AES or TKIP/AES) for data encryption.
Select TKIP if your wireless clients can all use TKIP.
Select AES if your wireless clients can all use AES.
Select TKIP/AES to allow the wireless clients to use either TKIP or AES.
This check box is available only when you select WPA2-PSK or WPA2 in the
Security Mode field.
Select the check box to have both WPA-PSK and WPA wireless clients be able to
communicate with the ZyXEL Device even when the ZyXEL Device is using
WPA2-PSK or WPA2.
Specify how often wireless stations have to resend usernames and passwords
in order to stay connected. Enter a time interval between 10 and 9999 seconds.
Note: If wireless station authentication is done using a RADIUS server, the
reauthentication timer on the RADIUS server has priority.
The ZyXEL Device automatically disconnects a wireless station from the wired
network after a period of inactivity. The wireless station needs to enter the
username and password again before access to the wired network is allowed.
Chapter 8 Wireless LAN
103