Front Panel - Toshiba XM-6401B Instruction Manual

THE FRONT PANEL
Eject Button - The EJECT button is used to open the disc tray so you
can install or remove a disc. The EJECT Inhibit Jumper must be set to
OFF in order for the EJECT button to function. (If jumper is in ON
postion, the drive accepts all eject control from the computer).
Busy Light - When you install a disc into the CD-ROM drive, the
BUSY light flashes slowly as it attempts to locate the disc. One of the
following will occur:
• BUSY light goes out. The CD-ROM drive is ready to read data
from the disc.
• BUSY light flashes slowly. The disc may be dirty.
• BUSY light remains ON. The CD-ROM is accessing data.
• BUSY light remains ON indefinitely. The CD-ROM is experienc-
ing an error.
Headphone Jack - The headphone jack is used to connect headphones
to your CD-ROM.
Emergency Eject Hole - The emergency eject hole is to be used only
when the CD tray will not open when EJECT button is pressed. See
page 20 for additional information.
Volume Control - The volume control is used to adjust the level of the
audio signal from the headphone jack. The volume control does not
affect the level of the signal sent to the audio output on the back of the
drive.
TOSHIBA XM-6401B/TXM6401F1 CD-ROM Drive
17