Check For Dial Tone; Tone/Pulse Selection; Removable Face Plate And Base Plates - VTech gz2438 User Manual

Setup

Check for Dial Tone

After the battery is charged, connect the modular telephone cord between a live phone
jack and the jack located on the bottom of the Base Unit. Pick up the Handset and press
ON. You should hear a dial tone.

Tone/Pulse Selection

Your gz 2438 is preset for tone dialing. See Telephone Operation for details.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT! FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and extension Handsets away
from electronic equipment, such as personal
computers, television sets and microwave ovens.
3. In locations where there are multiple cordless
telephones, separate Base Units as much as
possible.
4. Install your telephone equipment away from heat
sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
Removable Handset and Base Plates
Your gz 2438 comes with additional Handset
and Base plates of various colors. You can
interchange these plates to suit your mood or
room decor.
Handset Plate
Carefully remove the Handset face and/or
back plate by pressing the button on the top of
the Handset, then pulling the plate off. Attach
the new face and/or back plate by snapping
the lower portion, then the upper portion into
position.
Base Plate
Carefully remove the Base plate by pressing the button on the right side of the Base Unit,
then pulling the plate off. Align the new Base plate, making sure the antenna passes
through the appropriate slot. Secure the plate by snapping it into position.
Remove
Remove
Re-attach
5
Re-attach