Speed Dial; Store A Number/Name In The Speed Dial Memory - VTech gz2438 User Manual

Speed Dial

You can store as many as nine telephone numbers with names (up to 15 characters and 24
digits in each location) you dial frequently into the Speed Dial memory locations you assign
in the Handset.
NOTES:
1. The entries you store in Speed Dial memory will be marked 01 through 09 in the
telephone directory.
2. Press OFF at any time to exit speed dial mode.
Store a Number/Name in Speed Dial Memory
1. Press PROG.
2. Press or until the screen displays SPEED DIAL.
3. Press SELECT. The screen displays ENTER 1-9.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone sounds
and you cannot store a new entry until you delete an entry in the speed dial memory or the
telephone directory.
4. Press the key (1 through 9) for the memory location where you're storing this entry.
The screen displays ENTER NAME.
NOTE: Take caution when assigning Speed Dial location numbers in memory. If the location
already has an entry stored, the new entry will be stored over the old and it will be deleted.
Be careful to not save over entries you do not wish to delete from memory.
5. Using the chart below, enter up to 15 characters for the name you're storing with the
number. Use to backspace and make corrections; use
6. When you finish entering the name, press SELECT or PROG. The screen displays
ENTER NUMBER.
7. Enter the telephone number. Use
DIAL/PAUSE to store a pause in the dialing sequence.
to advance and add a space.
to backspace and make a correction. Press RE-
11