Table of Contents
Advertisement
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing
BEFORE SERVICING ANY GAS CARRYING COMPONENTS.
TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifi cally
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before
commencing servicing, particularly before removing any
of the following: - control panel, side panels, hotplate tray
or any electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
Note - References to LH and RH oven apply as viewed
from the front.
Contents
1 To Remove the Control Panel
2. To Remove Hotplate
1
To Remove the Control Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove the
4 fi xing screws underneath the control panel.
Remove the handrail by removing the 2 end bracket fi xing
screws.
Remove the 2 cross-headed screws that were hidden by
the handrail end brackets.
The control panel should drop down slightly. It is held at
32
the top by two holes in the top edge one at each end that
32
locate on tags on the inner panel.
33
Clear the holes from the inner panel and pull the control
33
panel forward.
33
33
33
33
33
34
Disconnect the wiring from the rear.
34
Reassemble in reverse order. When replacing leads refer to
34
the wiring diagram. Check operation of timer.
34
2. To Remove Hotplate
34
Disconnect from electricity supply.
34
Remove the pan supports and burner heads. Remove the
34
screws holding the hotplate burners to the hotplate.
34
Remove the 6 screws holding the hotplate tray to the
35
cooker.
35
35
35
35
35
35
36
36
32
Advertisement
Chapters
Table of Contents
