Table of Contents
Advertisement
Code
Operator Message Displayed
E230
Open access door to correct error
E231
Press JOG, and try again
E232
Close all access doors and RUN
E234
Press JOG, and try again
E235
Turn main power OFF and ON
E236
E238
User function string invalid
E240
Enter correct level of IA - refeed
E241
E242
E243
E244
E245
E246
Conflicting input - what level?
E267
Clear error, re-enter IA
E280
Feeder off due to host request
E281
OCR was reset - restart batch
E282
Comm buffer full - please wait
A-41069
January 1993
Description/Action Required
Open the access door.
Verify that all operator accessible areas are
properly closed.
Press the Run key to continue.
Press the Jog key. Press the Run key. Try again.
Close all access doors.
Press the Run key to continue.
Press the Jog key. Press the Run key. Try again.
Turn the side panel switch off.
Turn the main power switch off.
Wait five (5) to ten (10) seconds.
Turn the main power switch on.
Turn the side panel switch on.
If the error repeats, call service.
The P-Key, End-of-Batch, etc. definition made
during installation is invalid. Correct the definition
using the Mode Setup Software.
Set or change the document image level or use the
Next key to enter a new Image Address.
Press the Run key to continue.
Set or change the document image level to
confirm the proper document image level.
Press the Run key to continue.
Press the Clear key.
Use the NEXT key to enter an Image Address.
Press the Run key to continue.
System is busy.
Feeder will be reactivated when the system is no
longer busy.
Wait until the message clears and continue.
Use the NEXT key to enter a starting Image
Address.
Rerun the batch.
System is busy.
Wait until the message clears and continue.
6-5
Advertisement
Table of Contents
