Table of Contents
Advertisement
23
STEP 4
461
•
IP Version—Select either IPv4 or IPv6.
•
IPv6 Address Type—Select either Link Local or Global.
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link Local Interface—If the IPv6 address type is Link Local, select whether
it is received through a VLAN or ISATAP.
•
Recipient IP Address/Name—Enter the IP address or server name of
where the traps are sent.
•
UDP Port—Enter the UDP port used for notifications on the recipient device.
•
Notification Type—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
•
Timeout—Enter the number of seconds the device waits before re-sending
informs.
•
Retries—Enter the number of times that the device resends an inform
request.
•
Community String—Select from the pull-down the community string of the
trap manager. Community String names are generated from those listed in
the Community page.
•
Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a time.
•
Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the Notification
Filter page.
•
Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the Notification Filter page).
Click Apply. The SNMP Notification Recipient settings are written to the Running
Configuration file.
Cisco Small Business 300 Series Managed Switch Administration Guide
SNMP
Notification Recipients
Advertisement
Table of Contents
