10
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
157
Click Apply
To enable the Auto Smartport feature on one or more interfaces, open the
Smartport > Interface Settings page.
Select the interface, and click Edit.
Select Auto Smartport in the Smartport Application field.
Check or uncheck Persistent Status if desired.
Click Apply.
Workflow2: To configure an interface as a static Smartport, perform the
following steps:
To enable the Smartport feature on the interface, open the Smartport > Interface
Settings page.
Select the interface, and click Edit.
Select the Smartport type that is to be assigned to the interface in the Smartport
Application field.
Set the macro parameters as required.
Click Apply.
Workflow3: To adjust Smartport macro parameter defaults and/or bind a
user-defined macro pair to a Smartport type, perform the following
steps:
Through this procedure you can accomplish the following:
•
View the macro source.
•
Change parameter defaults.
•
Restore the parameter defaults to the factory settings.
•
Bind a user-defined macro pair (a macro and its corresponding anti-macro)
to a Smartport type.
1. Open the Smartport > Smartport Type Settings page.
2. Select the Smartport Type.
Cisco Small Business 300 Series Managed Switch Administration Guide
Smartport
Common Smartport Tasks