Table of Contents
Advertisement
SEAT REMOVAL AND INSTALLATION
Front Seat Bases
"Step & roll" quick-release seat
base attachments engage re-
cessed floor strikers (supports).
A foot-activated release pedal
is located at the rear of the seat
base. Stepping on the pedal
disengages the attachments
and deploys the seat base rear
wheels.
Note: For ease of disengage-
ment, move the seat to the full
forward and upright position be-
fore removing seat(s). Push the
seat back forward and upward
while stepping on foot pedal
(ensures full deployment of rear
wheels).
Page 40
Push seat back forward and upward
while stepping on foot pedal.
Foot
Pedal
Front Seat Removal Instructions
1. Move seat to full forward and
upright position.
2. Caution! Disconnect seat
wiring harness before
removing a front seat base.
Connect harness to seat base
socket. See page 37-39 for
wiring harness details.
3. Depress foot pedal (push
down). Note: Push seat back
forward and upward while
stepping on foot pedal. See
Photos and Figures A-D.
4. Pull up and back on the rear
of seat (deploy front wheels).
See Figures E and F.
5. Roll seat base out of vehicle
as shown.
Advertisement
Table of Contents
