Brocade Communications Systems ServerIron ADX 12.4.00a Security Manual page 54

1
Traffic segmentation
The contents of the display are defined in the following table.
TABLE 2
This field...
PORT-VLAN
Bridge VLAN
Name
Priority level
Spanning tree
Untagged Ports
Tagged Ports
Uplink Ports
DualMode Ports
You can use the show vlan-bridge command to show all of the bridged VLANs as follows.
ServerIron# show vlan-bridge
IN-VLAN
222
333
Syntax: show vlan-bridge
The contents of the display are defined in the following table.
TABLE 3
This field...
IN-VLAN
Bridge VLAN
40
Display from show vlan command
Displays...
The VLAN ID of the PORT VLAN configured.
The VLAN ID of the associated bridge VLAN.
The name of the VLAN as configured. If no name is configured, "{None]" is
displayed
The QoS priority as configured. If no priority value is configured the value
displayed will be "0".
Displays the value of spanning tree protocol on this VLAN. Values can be "On"
or "Off".
Displays the untagged port members of the VLAN.
Displays the tagged port members of the VLAN.
Displays the uplink port members of the VLAN.
Displays the port members of the VLAN that are in dual mode.
Bridge VLAN
333
222
Display from show vlan-bridge command
Displays...
The VLAN ID of the PORT VLAN configured.
The VLAN ID of the associated bridge VLAN.
ServerIron ADX Security Guide
53-1002440-03