Configuring Http Trl Defaults - Brocade Communications Systems ServerIron ADX 12.4.00a Security Manual

2. Configure an HTTP TRL client maximum connection.
3. Configure the action to take if a client exceeds the configured maximum connections

Configuring HTTP TRL defaults

Use the following procedures to configure the HTTP TRL default rate limit and the default maximum
connection.
Configuring HTTP TRL default rate limit
To configure HTTP TRL default rate limit, follow these steps.
1. Define an HTTP TRL policy.
2. Configure an HTTP TRL default rate limit.
3. Configure the action to take if a client exceeds the configured rate limit (optional).
Configuring HTTP TRL default maximum connection
To configure HTTP TRL default maximum connection, follow these steps.
1. Define an HTTP TRL policy.
2. Configure an HTTP TRL default maximum connection.
3. Configure the action to take if a client exceeds the configured maximum connection (optional).
ServerIron ADX Security Guide
53-1002440-03
Syntax: [no] http-trl-policy <policy-name>
ServerIronADX(config-http-trl-p1)# client-name c1 max-conn 10
Syntax: [no] client-name <client-name> max-conn <max-conn-value>
<max-conn-value>—specifies maximum number of connection client can setup.
(optional).
ServerIronADX(config-http-trl-p1)# client-name c1 exceed-action reset
Syntax: [no] client-name <client-name> exceed-action reset
ServerIronADX(config)# http-trl-policy p1
Syntax: [no] http-trl-policy <policy-name>
ServerIronADX(config-http-trl-p1)# default monitor-interval 1 10 20 0
Syntax: [no] default monitor-interval <interval-value> <warning-rate> <shutdown-rate>
<holddown-interval>
ServerIronADX(config-http-trl-p1)# default exceed-action reset
Syntax: [no] default exceed-action reset
ServerIronADX(config)# http-trl-policy p1
Syntax: [no] http-trl-policy <policy-name>
ServerIronADX(config-http-trl-p1)# default max-conn 10
Syntax: [no] default max-conn <max-conn-value>
ServerIronADX(config-http-trl-p1)# default exceed-action reset
Configuring HTTP TRL
1
19