Location - Skil 3540 Operating/Safety Instructions Manual

W RNING
cut only one workpiece at a time.
Be certain the tile saw is mounted or placed on a
level, firm work surface before using.
This tool is not equipped with provisions for
attaching an auxiliary fence.
Do not use another person as a substitute for a table
extension or as additional support.
The cutoff piece must not be jammed against or
pressured by any other means against the spinning
tile blade.
let the blade reach full speed before contacting the
workpiece.
if the workpiece or blade becomes jammed or
bogged down, turn tile saw "off" by releasing
switch. wait for all moving parts to stop and unplug
the tile saw, then work to free the jammed material.

locaTioN

To reduce the risk of electrocution,
DoN'T unplug the cord if the plug or
receptacle gets wet. Disconnect the fuse or circuit
breaker that supplies power to the tool. Then unplug
and examine for presence of water in the receptacle.
Safety
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
There are additional safety instructions for particular
operations of the saw in the operating section. Read
the rest of the manual for safe operation.
POWER
SUPPLY
CORD
"SaVe TheSe iNSTRUcTioNS"
4.
Some dust created by power sanding,
sawing, grinding, drilling, and other
TILESAW
TILESAW
SUPPORT
DRIP
LOOP