Tool Use And Care; Service; Safety Rules For Tile Saws - Skil 3540 Operating/Safety Instructions Manual

W RNING
Use clamps or other practical way to secure and
support the workpiece to a stable platform.
Do not force tool. Use the correct tool for your
application.
Do not use tool if switch does not turn it "oN" or
"off".
Disconnect the plug from the power source before
making any adjustments or changing accessories.
Keep cutting tools sharp and clean.
inspect guards before using a tool. Keep guards in
place. check moving parts for binding or any other
condition that may affect the normal operation or
safety features of the tool. if damaged, have tool
serviced before using the tool.
Do not alter or misuse tool.
The use of any other accessories not specified in this
manual may create a hazard.
Tool service must be performed only by qualified
repair personnel.
when servicing a tool, use only identical replacement
parts. follow instructions in the maintenance section
of this manual.
Safety
• To reduce the risk of electrocution, keep all
connections dry and off the ground. Do not touch
plug with wet hands.
• To reduce the risk of electric shock, plug tile saw into
Ground fault circuit interrupter (Gfci) protected
outlet only. if a Gfci protected outlet is not available,
use a portable receptacle with built-in Gfci
protection
• Disconnect saw from power source before making
adjustments, servicing, cleaning, or changing blade.
• Replace damaged tile blades before operating.
• Use tool only with smooth edge tile blades free of
openings and grooves.
• after turning saw off, wait for blade to stop before
removing cutoff pieces or changing settings.
• Use top guard for every operation for which it can be
used.
Do not reach in back of the saw blade with either
hand to hold down or support the workpiece, remove
scraps, or for any other reason.
always disconnect the power cord from the power
source before making any adjustments or attaching
any accessories.
Do not use the saw until the table is clear of all tools,
scraps, etc., except the workpiece and related feed or
supported devices for the operation planned.
empty water from tile saw base before transporting.
"SaVe TheSe iNSTRUcTioNS"
3.
Safety Rules for
Tile Saws