Slide the power supply into the power supply bay until the device locks into place.
2.
Connect the power cord to the power supply.
3.
Connect the power cord to the power source.
4.
Be sure that the power supply LED is green
5.
Be sure that the front panel external health LED is green.
6.
Internal solid state drive expansion bay option
Power down the server (on page 25).
1.
Extend the server from the rack (on page 25).
2.
Remove the access panel (on page 26).
3.
Remove the SPI board (on page 28).
4.
Install the solid state drive.
5.
Connect the cable.
6.
("Power supply
LED" on page 12).
Hardware options installation 53