A&D UA-702 Instruction Manual page 8

5. When the measurement is complete, the buzzer sounds for about one second.
The systolic pressure is displayed on the left and the diastolic is displayed on the
right. The pulse alternates with the systolic and diastolic displays.
6. Press the exhaust valve button to completely release the air from the cuff.
• When a measurement is made with insufficient pressure, the
appear. Re-pressurize the cuff to a pressure that is about 30 to 40 mmHg
higher than the previous time.
• When a measurement is made with an erratic pulse or in a very noisy
environment,
7. Turning the power off
Press the POWER button to turn the power off. The device will be in standby mode.
8. Subsequent measurements
If a subsequent measurement is required, turn off the power and turn it on
again. When the "0 " appears, the device is ready for another measurement.
Note
Allow at least ten minutes between measurements on the same person.
9. Automatic power-off function
If the device is left on after a measurement, it will turn off automatically after about
three minutes. It may be turned off at any time by pressing the POWER button.
Measurements
will appear.
ENGLISH 7
mark will