Sharp XE-A203 - Cash Register Thermal Printing Graphic Logo Creation Service Manual page 6

7. DRAWER
[OUTLINE]
• Standard equipment: Yes (1)
• Max. number of additional drawers: 1
• The drawer consists of:
1) Drawer box (outer case) and drawer
2) Money case
3) Coin case
4) Lock (attached to the drawer)
[SPECIFICATION]
1) DRAWER BOX AND DRAWER
Type SEC
Model name of SJ415
the drawer box
Size (mm) 330(W) x 418(D) x 98(H) 355(W) x 423(D) x 110(H)
Material Plastic
Bell
Release lever Standard equipment: situated at the bottom
Drawer open
sensor
2) MONEY CASE
Type
Separation from the drawer
Separation of the bill compartments
from the coin compartments
Bill separator
Number of compartments
Layout:
4B/5C (U version)
3) Drawer Lock Key
This key locks and unlocks the drawer. To lock it, turn 90 degrees coun-
terclockwise. To unlock it, turn 90 degrees clockwise.
SECL
SJ423
—
—
SEC SECL
Disallowed
Allowed
—
4B/5C 5B/6C
5B/6C (A version)
XE-A203U/XE-A203A SPECIFICATIONS
8. USB PORT
[DEVICE]
USB B Type
[OUTLINE]
This ECR has 1 port.
This is used in order to connect with a personal computer.
[SPECIDICATIONS]
1) Transmission tate
USB 2.0 Full Speed Max. 12Mbps
2) Connector
USB B Type
3) Pin assign
1Pin 5V
2Pin -D
3Pin +D
4Pin GND
9. BATTERY
1) MEMORY BACK UP BATTERY
For memory back up, the dry battery AA (3 pieces) are needed.
1. Memory holding time:
Approximate 1 year after New dry batteries are inserted.
2. Battery exchange method:
When the low battery symbol "L" lights up, batteries (3 pieces)
exhange by the following method, with 2 days.
1) Power on the ECR.
2) Mode switch turn to "REG" mode.
3) Release the OLD dry batteries (3 pieces).
4) Insert the NEW dry batteries (3 pieces).
5) Confirm the low battery symbol "L" lights off.
2) LOW BATTERY
Low battery indication will appear on the left side of display when the
battery voltage is low.
CASE 1: When any numeric entry & any item entry is not done or just
after finalization.
The machine can indicate the low battery condition. (Always)
CASE 2: When numeric entry or item entry is done.
Battery condition will not appear.
Exceptionally, when the power is restored after a power failure, the
low battery condition will appear on the display only when the bat-
tery is low.
And the indicator will disappear after any key entry.
– 4 –