Configuring The Cisco 700 Router As An Rcapi Server; Rcapi Command Summary - Cisco 700 Series Configuration Manual

Configuring the Cisco 700 Router as an RCAPI Server

Configuring the Cisco 700 Router as an RCAPI Server
This section describes how to configure the Cisco 700 series router to be an RCAPI server.
By default, RCAPI is disabled in the router. Enabling RCAPI causes the router to become
an RCAPI server. When RCAPI is enabled, the router listens for incoming RCAPI
messages from PCs connected on its LAN side. By default, the router listens for RCAPI
messages on TCP port 2578.
Figure 6-1 illustrates the configuration used in this example. The PCs in the figure have
RVS-COM software installed.
Figure 6-1
Local PC
IP address
192.168.2.2

RCAPI Command Summary

Following is the command summary for configuring the RCAPI on the local Cisco 700
series router.
set rcapi on
set dir 5554000
set rcapi 1 number 5554000
set rcapi server port 2578
reboot
6-4 Cisco700 Series Router Configuration Guide
RCAPI Server Configuration Example
Local 7xx
router
IP address
192.168.2.1
Directory numbers
5554000/5552000
Remote 7xx
router
IP address
192.168.3.1
Directory numbers
5553000/551000
Remote PC
IP address
192.168.3.2