Cisco 765 Series Router Commands - Cisco 700 Series Configuration Manual

DHCP Server with PAT and IPCP Dual-Destination PPP Negotiation Example

Cisco 765 Series Router Commands

Following are the commands for configuring the remote Cisco 765 series router as a DHCP
server with PAT and IPCP multilink PPP to two routers running Cisco IOS software:
set system 765
set ppp secret client
set ppp password client
set dhcp server
set dhcp address 172.168.99.2 128
set dhcp netmask 255.255.255.0
set dhcp gateway primary 172.168.99.1
set ip pat porthandler ftp 172.168.99.3
cd lan
set ip routing on
set ip address 172.168.99.1
set ip netmask 255.255.255.0
set user 2500
set ppp clientname 2500
set 1 number phone_number
set 2 number phone_number
set ip routing on
set ip route destination 0.0.0.0/0 gateway 30.169.100.2
set ip address 30.169.100.1
set ip netmask 255.255.255.0
set ip pat on
set active
set user 4500
set ppp clientname 4500
set 1 number phone_number
set 2 number phone_number
set ip routing on
set ip route destination 120.50.40.0/0 gateway 173.100.10.2
set ip address 173.100.10.1
set ip netmask 255.255.255.0
set ip pat on
set active
Note
the IP route destination must be specified, using the set ip route destination command.
5-14 Cisco700 Series Router Configuration Guide
If you create a multiple destination configuration with PAT enabled in both profiles,