Product Overview; Installing The Discharge Chute - Toro Snow Blower 38515 Operator's Manual

3. Hook the end of the control cable spring into the
bottom hole of the control bar (Figure 4).
4. Fully insert the handle bolts (Figure 5).
Important: Ensure that you do not pinch the
control cable (Figure 5).
5. Tighten the knobs until they are snug.
6. Adjust the control cable. Refer to Adjusting the
Control Cable.
2. Installing the Discharge
Chute
1 Discharge chute
1 Chute handle
3 Phillips head screws
3 Washers
3 Locknuts
Procedure
Install the discharge chute as shown (Figure 6).
Figure 4
Figure 5

Product Overview

1. Discharge chute
2. Chute handle
3. Control bar
4. Handle
5. Control panel
6
Figure 6
Figure 7
6. Knobs
7. Handle bolt (2)
8. Rotor blades
9. Fuel tank cap