Standard Operation - Command Communications ComSwitch 5500 Operator's Manual

system typically has features like call holding,
music on hold, conference calling, and intercom
paging.
The diagram shows telephone devices
connected to the CS 5500 for a telephone
system; follow the same procedures if you have
a mini-telephone system in your home or small
office.
For the CS 5500 to operate properly, it must be "in front"
of the telephone system. In other words, it must connect
directly to the incoming telephone line.
Connect the other equipment as previously shown.
CAUTION: You should be familiar with telephone wiring to complete this installation. If you have any questions or are not
confident that you can complete this installation procedure, contact the Customer Service Center in the "Warranty" section of this
guide or a professional installer for further instructions.
Do not plug the CS 5500 into a telephone system phone jack. You may damage your phone system.
Using the CS 5500
In this section, there are special operating notes you should read before operating
the CS 5500. This section follows an overview of the CS 5500 standard operations
and instructions for answering and transferring your incoming calls.
CS 5500 Operator's Guide

Standard operation

The CS 5500 has 2 modes of operation, Automatic mode and Semi-Automatic mode. The factory setting is in the Automatic mode.
All equipment on that line (telephone system, fax, computer
modem, and so on) must connect directly to the CS 5500.
4