Up/Down Force; Erase - Open/Close Travel Limit; Contact Reverse Test - Genie 1022 Owner's Manual

1,
.
3.
,
By turning the Close Force Control _; clockwise,
the CLOSE force can be increased. By turning
the Close Force Control _; counter-clockwise,
the CLOSE force can be decreased. Set the
CLOSE force level at the minimum force required
to close door without reversing.
Once the desiredlevel is selected,this storesthe
maximum force levelfor the CLOSE direction in memory. !iliiiii::iiiii!ii;:ii!iill
By turning the Open Force Control _4 clockwise, the i!:i!:il i:_:ii::iiii;i:!iiii::i_:
OPEN force can be increased. By turning the Open :iiiii::ii!ii:iiiii!i!i!iii i:iii;il
Force Control _J counter-clockwise, the OPEN force
can be decreased. Set the OPEN force level at the ............................
minimum force required to open door without stopping.
Once the desired level is selected, this stores
the maximum force level for the OPEN direction
in memory.
1. Press and hold both of the "SET" buttons
(@& I_) together until the green indicator
light blinks (about 5 seconds).
2. All close and open travel limit settings are
erased. Then follow the steps on page 20 to
reprogram close and open travel limits.
NOT&-: The opener w_J_ not c_ose _he doer
automatically unless _he Safe-T.Beam _"System is
installed.
The force adjustments and limit switch settings
MUST BE COMPLETED before testing.
1. Testing.
• Open garage door using wall button.
- Place a 2" x 4" board (laid flat) under center
of garage door opening (Fig. 6-6).
• Close door using wall button.
• When door contacts board, the door must stop
(within 2 seconds) and reverse direction
returning to open position.
2. Adjustment.
• If the door does not properly reverse.
- Check to see if door has "close" limit
programmed. It should not have reached its
"close" limit before hitting board.
- If the door STOPS but does not reverse,
decrease "CLOSE FORCE" control _
setting slightly (turn it counter-clockwise).
• Test again. Repeat as necessary until door
reverses upon contacting board.
2 PN# 3642036534, 02/26/2070 REV. 1