Safe-T Beam System Installation; Mounting Brackets - Genie 1022 Owner's Manual

NOTE: For SaYe-T.BeamC_,screws, _Mre, and
insulated s_ap_es _ocate _,,_:ems a,,d Bag 8 frown Box 3,
1, Mounting brackets.
• Mark both sides of garage door frame or wall no
higher than 6" and no lower than 5" above floor
(Fig. 4-1),
• Hold bracket against door frame or wall.
- Check if brackets extend out from wall far
enough, so tongue of bracket is beyond door,
tracks or any door hardware.
-If not:
a) Mounting bracket extensions are available
through an authorized Genie _ Dealer.
b) Blocks of wood, etc. may be substituted for
extensions.
• Center bracket on your mark (Fig. 4-2).
• Fasten each with 2 screws (Fig. 4-2).
NOTE: M, o un_ing bmcket_ _._,,'_'_ b_,_ a_ached to _._he.
fioo_ o_concrete _":_t_ us,_:_g c oncrd_ _nch_'_
_ot pro_e,d).
2. Mounting Safe-T-Beam _'Source (Red LED) and
Sensor (Green LED),
• If garage has only one garage door.
- Determine which side of garage receives most
direct sunlight (Fig. 4-4).
- Red LED should always be on sunny side
whenever possible (Fig. 4-4).
, For multiple doors.
- Preventing crossed signals is critical.
- Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 4-4).
N077i; ?_ he_p _rever# fni°e_'f_rence from su_,
_hough extended
no further out from _'he waft
where f_ will spend morn time in shadow.
• Slide sourcelsensor onto tongue of bracket until
it clicks into place (Fig. 4-3).
3a. Wiring (If NOT pre-wired).
• Route wire from Safe-T-Beam" to power
head using method shown in (Fig. 4-5a).
• Securely fasten wires to wall and ceiling 5:P
as you go (Fig. 4-6 on next page).
-Use insulated staples.
-Staples should be snug only,
Insulated
Staple
i!ii ii !! i!i! iiiiiiiiiiiiiii!iii iiiii!i!iii!!iiiiiiiiiiiii!iiiii!i!ii!iiii!i ii!iiii iiiiii
:_!i ;iil;:iiiiii _ }iiiiii}iiil i!i;i_i_; i_!ii;iii!iii,iiii_ii_,ii ii_i_i!i}ili i} i,:! ili:,:,! i;_!
::'.: : !i:[ _i!i[i !-_if_[i[i _fil ! [i: iii_[i[i!-'.- )_'_ _i i_!iiii,ili: if_i!iiii:_ili,;h::,! i f i:i
I
PN# 3642036534, 02/26/2010 REV. t
t7